Model Without Keyless Access With Push Button Start System

CAUTION: When the body integrated unit is replaced, registration of the immobilizer system is required. For details, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.

Step	Check	Yes	No
1 CONFIRM NUMBER OF REGISTERED IMMOBILIZER KEY. Confirm the number of registered immobilizer key. For details, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.	Is the number of registration 0?	Register the immobilizer system.	Go to step 2 .
2 CHECK SECURITY INDICATOR LIGHT. Remove the ignition key from ignition switch. Wait at least 60 seconds.	Does the security indicator light blink?	Go to step 3 .	Check the security indicator light circuit. <Ref. to CHECK SECURITY INDICATOR LIGHT CIRCUIT , INSPECTION, Diagnostics Chart for Security Indicator Light.>
3 CHECK KEY SWITCH. Insert the ignition key in the ignition switch. (OFF or ACC)	Does the security indicator light remain blinking?	Check the key switch circuit. <Ref. to CHECK KEY SWITCH CIRCUIT , INSPECTION, Diagnostics Chart for Security Indicator Light.>	Go to step 4 .
4 CHECK SECURITY INDICATOR LIGHT. Check the security indicator light status in the condition of step 3.	Does the security indicator light go off?	Go to step 7 .	Go to step 5 .
5 CHECK SECURITY INDICATOR LIGHT. Turn the ignition switch to ON.	Does the security indicator light go off?	Go to step 7 .	Go to step 6 .
6 CHECK ENGINE START. Turn the ignition switch to START.	Does the starter operate?	Check the LAN communication system. <Ref. to Basic Diagnostic Procedure .>	Go to step 8 .
7 CHECK ENGINE START. Turn the ignition switch to START.	Does the engine start?	Immobilizer system is normal.	Go to step 9 .
8 CHECK DTC. Read the DTC of body integrated unit and ECM and time stamp using Subaru Select Monitor. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .> NOTE: For time stamp, <Ref. to TIME STAMP , CAUTION, General Description.>	Is DTC displayed?	Go to step 10 .	Replace the body integrated unit. <Ref. to Body Integrated Unit .>
9 CHECK DTC. Read the DTC of body integrated unit and ECM and time stamp using Subaru Select Monitor. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .> NOTE: For time stamp, <Ref. to TIME STAMP , CAUTION, General Description.>	Is DTC displayed?	Go to step 10 .	Perform the diagnosis for engine system. <Ref. to ENGINE , PROCEDURE, Basic Diagnostic Procedure.> <Ref. to ENGINE , PROCEDURE, Basic Diagnostic Procedure.>
10 CHECK FREEZE FRAME DATA. Using the Subaru Select Monitor, check the Freeze Frame Data.	Are the data recorded?	Record the data. Go to step 11 .	Go to step 11 .
11 CHECK DTC. Check the displayed DTC.	Are DTCs irrelevant to the immobilizer displayed?	Perform the diagnosis according to DTCs irrelevant to the immobilizer first.	Go to step 12 .
12 PERFORM DIAGNOSIS. Inspect using the "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". <Ref. to DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) .> Repair the trouble cause. Perform the Clear Memory Mode. <Ref. to CLEAR MEMORY MODE .> Read DTCs again. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>	Is DTC displayed?	Inspect using the "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". <Ref. to DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) .>	Finish the diagnosis.