MODELS WITHOUT EyeSight
CAUTION:
- When installing the VDCCM & H/U to the bracket - hydraulic unit, make sure that there is no oil adhered to the bolts and the threads of VDCCM & H/U. If the oil is adhered, degrease it carefully before tightening.
- Connect the VDCCM & H/U connector securely.
- When installing the VDCCM & H/U, replace the damper - hydraulic unit, spacer and nut with new parts.
- Install the VDC control module & hydraulic control unit (VDCCM & H/U) in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Description". Ref. to VDC CONTROL MODULE & HYDRAULIC CONTROL UNIT (VDCCM & H/U) , COMPONENT, General Description.
- Install the air intake boot. Ref. to INSTALLATION , Air Intake Boot.
- Connect the battery ground terminal. Ref. to BATTERY .
- Bleed air from the brake system. Ref. to Air Bleeding .
- Perform parameter confirmation, selection, and registration.NOTE:
- When the VDCCM & H/U is replaced with a new part, be sure to perform the selection registration operation.
- When the registration has not been performed, the DTC code "Parameter selection error" is detected together with the ABS/EBD/VDC warning light illumination.
- Check that the applied model and grade of the relevant vehicle are included. Ref. to PARAMETER CHECK , OPERATION, Subaru Select Monitor.
- If the applied model and grade of the target vehicle are not included, perform parameter selection and registration. Ref. to PARAMETER SELECTION , OPERATION, Subaru Select Monitor.
- Perform "VDC sensor midpoint setting mode". Ref. to VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).