LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle & Differential >> Front Differential Assembly >> Removal

Front Differential Assembly: Removal

  1. Remove the manual transmission assembly from the vehicle. Refer to REMOVAL .
  2. Remove the transfer case together with the extension case assembly. Refer to REMOVAL .
  3. Remove the transmission case. Refer to REMOVAL .
  4. Remove the drive pinion shaft assembly. Refer to REMOVAL .
  5. Remove the main shaft assembly for single-range. Refer to REMOVAL .
  6. Remove the front differential assembly.
    NOTE:
    • Do not confuse the right and left roller bearing outer races.
    • Be careful not to damage the oil seal of retainer.
      Fig 1: Removing Front Differential Assembly
      G08318991Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the differential side retainers using ST.

    ST 18630AA010 WRENCH COMPL RETAINER

    Fig 2: Removing Differential Side Retainer Using Wrench COMPL Retainer
    G06652376Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the bearing outer race from the transmission case.

    ST 398527700 PULLER ASSY

scientia non olet · About LEMON Manuals