LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seat System - Seats >> Power Seat System >> Inspection >> Unable To Set Positions Into Memory (With Memory)

Unable To Set Positions Into Memory (With Memory)

Step Check Yes No
1 CHECK SWITCH. 
  1. Disconnect the harness connector of memory switch assembly.
  2. Check memory switch. < Ref. to CHECK MEMORY SWITCH (WITH MEMORY FUNCTION) , INSPECTION, Power Seat System. >
 Is there any problem on the inspection result? Go to step 2  . Replace the memory switch assembly.
2 CHECK HARNESS. 
Measure the resistance between the memory switch connector and power seat control module connector.
Connector & terminal 
(R388) No. 13 - (D143) No. 2: 
(R388) No. 14 - (D143) No. 3: 
(R388) No. 15 - (D143) No. 8: 		 Is the resistance less than 10 Ω? Go to step 3  . Check power seat harness.
3 CHECK COMBINATION METER. 
Turn the ignition switch to ON and check the indicator light inside the meter.
  • AT/CVT model: Select lever shifted to "P" position.
 Does the indicator display "P"? Go to step 4  . Check the combination meter. < Ref. to INSPECTION , Combination Meter System. >
4 SYSTEM INITIALIZATION. 
Initialize memory seat system. < Ref. to ADJUSTMENT , Power Seat System. >		 Is the initialization completed successfully? Replace the power seat control module. < Ref. to UNABLE TO PERFORM INITIALIZATION , INSPECTION, Power Seat System. >
scientia non olet · About LEMON Manuals