Steering Satellite Switch: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Refer to CAUTION , General Description. >

Set the front wheels in straight ahead position.
Turn the ignition switch to OFF.
Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
Using TORX° bit T30 (1), loosen two TORX° bolts which secure the driver's airbag module.

Fig 1: Loosening TORX° Bolts Using TORX° Bit T30
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the airbag module connector on back of the airbag module. < Refer to PROCEDURE , Airbag Connector. >
Remove the steering wheel. < Refer to REMOVAL , Steering Wheel. >
Remove the screws to remove the lower cover from steering wheel.

Fig 2: Identifying Steering Wheel Screws
Courtesy of SUBARU OF AMERICA, INC.
Loosen the screws on the backside of the steering wheel and remove the satellite switch.

Fig 3: Identifying Steering Wheel Backside Screws
Courtesy of SUBARU OF AMERICA, INC.