LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Transmission - Control Systems (Except WRX STI) >> Select Lever >> Installation

Select Lever: Installation

  1. Set the select lever to the vehicle body.
  2. Tighten the four bolts to install the select lever assembly to vehicle body, and connect the connector.
    1. Temporarily tighten the bolt A.
    2. Tighten the bolt B.
    3. Tighten the bolt A.
    4. Tighten the bolts C and D.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 1: Locating Select Lever Assembly Mounting Bolts
    G07657034Courtesy of SUBARU OF AMERICA, INC.
  3. Install the harness clips to the bracket.
  4. Install the console cover and console box. < Ref. to INSTALLATION , Console Box. >
  5. Shift the select lever to "N" range.
  6. Install the blind.
    CAUTION: The blind should be installed so that it is securely caught by tabs of the plate guide COM-PL.
    Fig 2: Identifying Bracket Harness Clips
    G07657035Courtesy of SUBARU OF AMERICA, INC.
  7. Install the indicator assembly.
  8. Install the console front panel.
  9. Install the parking brake lever boot.
  10. Install the grip.
  11. Lift up the vehicle.
  12. Shift the range select lever to "N" range.
  13. Secure the cable to the bracket. < Ref. to INSTALLATION , Select Cable. >
  14. Adjust the select cable position. < Ref. to ADJUSTMENT , Select Cable. >
  15. After the completion of adjustment, confirm that the select lever operates properly at all range positions.
  16. Install the heat shield cover. < Ref. to INSTALLATION , Heat Shield Cover. >
  17. Install the rear exhaust pipe. < Ref. to INSTALLATION , Rear Exhaust Pipe. >
  18. Lower the vehicle.
  19. Connect the battery ground terminal.
  20. Inspect the following items. When a malfunction is found in the inspection, adjust the select cable and inhibitor switch. < Ref. to ADJUSTMENT , Select Cable. > < Ref. to ADJUSTMENT , Inhibitor Switch. >
  1. Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
  2. Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
  3. Select lever and indicator positions are matched.
scientia non olet · About LEMON Manuals