LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Automatic Transmission 4AT) >> Oil Pump Housing >> Installation

Oil Pump Housing: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Secure the oil pump housing with two nuts and a bolt.

    Tightening torque: 

    42 N.m (4.3 kgf-m, 31 ft-lb) 

    Fig 1: Identifying Oil Pump Housing With Nuts And Bolt
    G05021940Courtesy of SUBARU OF AMERICA, INC.
  2. Install the converter case to the transmission case assembly. < Ref. to INSTALLATION , Converter Case. >
  3. Install the reduction driven gear. < Ref. to INSTALLATION , Reduction Driven Gear. >
  4. Install the reduction drive gear. < Ref. to INSTALLATION , Reduction Drive Gear. >
  5. Join the transmission case and the extension case, and then install the rear vehicle speed sensor. < Ref. to INSTALLATION , Extension Case. >
  6. Insert the inhibitor switch and transmission connector to the stay.
    Fig 2: Identifying Inhibitor Switch And Transmission Connector
    G05021941Courtesy of SUBARU OF AMERICA, INC.
  7. Install the oil cooler pipe. < Ref. to INSTALLATION , ATF Cooler Pipe and Hose. >
  8. Install the oil charge pipe together with an O-ring. < Ref. to INSTALLATION , Oil Charge Pipe. >
  9. Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.

    Normal protrusion A: 

    50 - 55 mm (1.97 - 2.17 in) 

    Fig 3: Identifying Input Shaft
    G04990427Courtesy of SUBARU OF AMERICA, INC.
  10. Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
  11. Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
scientia non olet · About LEMON Manuals