LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Exterior/Interior Trim) >> Upper Inner Trim >> Removal

Upper Inner Trim: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. From the top side of the trim, remove the metal clip using a flat tip screwdriver.
    Fig 1: Removing Metal Clip Using Flat Tip Screwdriver
    G05023006
    CAUTION: When the metal clip comes off or becomes damaged, replace both trim and metal clips with new parts.
  2. Remove the front pillar upper trim.
    Fig 2: Identifying Clip
    G05023007
  3. Remove the front inside scuff plate, rear inside scuff plate and center pillar lower trim. < Ref. to REMOVAL , Lower Inner Trim. >
  4. Remove the cap on the upper side of the pillar trim, and remove the bolt inside.
    Fig 3: Identifying Trim Bolt
    G05023008
  5. Remove the center pillar upper trim.
    Fig 4: Locating Bolts
    G05023009
  6. Remove the seat belt lower anchor bolt at the center pillar lower port. (Driver's seat)
  7. Refer to the removal procedure of "FRONT SEAT BELT " for the passenger's seat. < Ref. to , OUTER SEAT BELT ASSEMBLY , REMOVAL, FRONT SEAT BELT. >
scientia non olet · About LEMON Manuals