LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Instrumentation/Driver Info) >> Combination Meter System >> Inspection >> Check Power Supply And Ground Circuit

Check Power Supply And Ground Circuit

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
POWER SUPPLY AND GROUND CIRCUIT SPECIFICATION

Step Check Yes No
1. CHECK POWER SUPPLY FOR COMBINATION METER. 
  1. Remove the combination meter. < Ref. to REMOVAL , Combination Meter. >
  2. Disconnect the combination meter harness connector.
  3. Turn the ignition switch to ON.
  4. Measure the voltage between combination meter connector and chassis ground.

    Connector & terminal 

    (i10) No. 3, No. 4 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Go to step 2.  Check the harness for open or short between the ignition switch and combination meter.
2. CHECK POWER SUPPLY FOR COMBINATION METER. 
Measure the voltage between combination meter connector and chassis ground.
Connector & terminal 
(i10) No. 1, No. 2 (+) - Chassis ground (-): 		 Is the voltage more than 10 V? Go to step 3.  Check the harness for open or short between the fuse and combination meter.
3. CHECK GROUND CIRCUIT OF COMBINATION METER. 
  1. Turn the ignition switch to OFF.
  2. Measure the resistance of harness between combination meter connector and chassis ground.

    Connector & terminal 

    (i10) No. 11, No. 12 - Chassis ground: 

 Is the resistance less than 10 ohm? Replace the meter case assembly. Repair the wiring harness.
scientia non olet · About LEMON Manuals