LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Baja Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Trans) >> 2-4 Brake >> Removal

2-4 Brake: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. < Ref. to REMOVAL , Automatic Transmission Assembly.>
  2. Extract the torque converter clutch assembly.

    < Ref. to REMOVAL , Torque Converter Clutch Assembly.>

  3. Remove the input shaft.
    Fig 1: Removing Input Shaft
    G02876103Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the air breather hose. < Ref. to REMOVAL , Air Breather Hose.>
  5. Lift-up lever behind the transmission harness connector and disconnect it from stay.
  6. Disconnect inhibitor switch connector from stay.
  7. Remove the oil charger pipe. < Ref. to REMOVAL , Oil Charger Pipe.>
  8. Remove the oil cooler inlet and outlet pipes with washers. < Ref. to REMOVAL , ATF Cooler Pipe and Hose.>
  9. Remove rear vehicle speed sensor, and separate the transmission case and extension case. < Ref. to REMOVAL , Extension Case.>
  10. Remove the reduction drive gear. (MPT model)

    < Ref. to REMOVAL , Reduction Drive Gear.>

  11. Remove the center differential carrier. (VTD model) < Ref. to REMOVAL , Center Differential Carrier.>
  12. Remove reduction driven gear.

    < Ref. to REMOVAL , Reduction Driven Gear.>

  13. Separation of torque converter clutch case and transmission case < Ref. to REMOVAL , Torque Converter Clutch Case.>
  14. Remove the oil pan and control valve body.

    < Ref. to REMOVAL , Control Valve Body.>

  15. Remove the oil pump housing. < Ref. to REMOVAL , Oil Pump.>
  16. Remove 2-4 brake seal.
    Fig 2: Removing 2-4 Brake Seal
    G02876104Courtesy of SUBARU OF AMERICA, INC.
  17. Take out the high clutch and reverse clutch assembly. < Ref. to REMOVAL , High Clutch and Reverse Clutch.>
  18. Take out the thrust needle bearing, planetary gear assembly and the low clutch assembly. < Ref. to REMOVAL , Planetary Gear and Low Clutch.>
  19. Remove snap ring.
    Fig 3: Removing Snap Ring
    G02876105Courtesy of SUBARU OF AMERICA, INC.
  20. Take out 2-4 brake return spring.
    Fig 4: Removing 2-4 Brake Return Spring
    G02876106Courtesy of SUBARU OF AMERICA, INC.
  21. Remove the 2-4 brake piston and piston retainer without damaging.
    Fig 5: Removing 2-4 Brake Piston & Piston Retainer
    G02876107Courtesy of SUBARU OF AMERICA, INC.
  22. Separate 2-4 brake piston and piston retainer.
    Fig 6: Separating 2-4 Brake Piston & Piston Retainer
    G02876108Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals