LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2002 >> Forester Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Automatic Transmission) >> 2-4 Brake >> Removal

2-4 Brake: Removal

WARNING: This page is about a different car, the 2003 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly from the vehicle. Refer to REMOVAL , Automatic Transmission Assembly.
  2. Extract the torque converter clutch assembly. Refer to REMOVAL , Torque Converter Clutch Assembly.
  3. Remove the input shaft.
    Fig 1: Removing Input Shaft
    G02093366Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the air breather hose. Refer to REMOVAL , Air Breather Hose.
  5. Lift-up lever behind the transmission harness connector and disconnect it from stay.
  6. Disconnect inhibitor switch connector from stay.
  7. Remove the oil charger pipe. Refer to REMOVAL , Oil Charger Pipe.
  8. Remove the oil cooler inlet and outlet pipes with washers. Refer to REMOVAL , ATF Cooler Pipe and Hose.
  9. Remove rear vehicle speed sensor, and separate the transmission case and extension case. Refer to REMOVAL , Extension Case.
  10. Remove reduction driven gear. Refer to REMOVAL , Reduction Driven Gear.
  11. Separation of torque converter clutch case and transmission case. Refer to REMOVAL , Torque Converter Clutch Case.
  12. Remove the oil pan and control valve body. Refer to REMOVAL , Control Valve Body.
  13. Remove the oil pump housing. Refer to REMOVAL , Oil Pump.
  14. Remove 2-4 brake seal.
    Fig 2: Removing 2-4 Brake Seal
    G02093367Courtesy of SUBARU OF AMERICA, INC.
  15. Take out the high clutch and reverse clutch assembly. Refer to REMOVAL , High Clutch and Reverse Clutch.
  16. Take out the thrust needle bearing, planetary gear assembly and the low clutch assembly. Refer to REMOVAL , Planetary Gear and Low Clutch.
  17. Remove snap ring.
    Fig 3: Removing Snap Ring
    G02093368Courtesy of SUBARU OF AMERICA, INC.
  18. Take out 2-4 brake return spring.
    Fig 4: Removing 2-4 Brake Return Spring
    G02093369Courtesy of SUBARU OF AMERICA, INC.
  19. Remove the 2-4 brake piston and piston retainer without damaging.
    Fig 5: Removing 2-4 Brake Piston & Piston Retainer
    G02093370Courtesy of SUBARU OF AMERICA, INC.
  20. Separate 2-4 brake piston and piston retainer.
    Fig 6: Separating 2-4 Brake Piston & Piston Retainer
    G02093371Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals