Knock Sensor: Installation

WARNING: This page is about a different car, the 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block.
Tightening torque:

24 N.m (2.4 kgf-m, 17.4 ft-lb)

NOTE: Extraction area of the knock sensor cord must be positioned at a 60° angle relative to the engine rear

Fig 1: Installing Knock Sensor To Cylinder Block
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Connecting Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler. Refer to INSTALLATION , Intercooler.
Connect the battery ground cable to battery.

Fig 3: Connecting Battery Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.