Front Seat Inner Belt Assembly: Removal

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See PRECAUTION ).

NOTE: Always use "TORX" socket wrench E10 when removing the front seat.

HINT:

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT SEAT ASSEMBLY LH (See REMOVAL )
REMOVE FRONT SEAT ASSEMBLY RH (See DISASSEMBLY )
REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
1. Disconnect the seat position sensor connector.
2. Remove the buckle switch connector.
3. Remove the 2 wiring harness clamps.
  
  Fig 1: Locating Wiring Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the wiring harness from the claw on the front seat cushion shield.
5. Remove the bolt and the front seat inner belt.
REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
1. Remove the buckle switch connector.
2. Remove the 2 wiring harness clamps.
  
  Fig 3: Locating Buckle Switch Connector And Wiring Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the wiring harness from the claw on the front seat cushion shield.
4. Remove the bolt and the front seat inner belt.