LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> U241E Automatic Transaxle >> Floor Shift Assembly >> Removal

Floor Shift Assembly: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE CONSOLE UPPER FRONT PANEL SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE REAR CONSOLE BOX ASSEMBLY  (See REMOVAL )
  5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 
    1. Remove the knob.
      Fig 1: Identifying Knob
      G05539421Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Disconnect the cable from the floor shift.
      Fig 2: Identifying Cable From Floor Shift
      G05539422Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE SHIFT LEVER ASSEMBLY 
    1. Disconnect the shift lock control ECU connector.
      Fig 3: Identifying Shift Lock Control ECU Connector
      G05539423Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and floor shift assembly.
      Fig 4: Identifying Bolts And Floor Shift Assembly
      G05539424Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals