Bleeding Brake System: Notes

NOTE: Use only DOT 3 brake fluid from a sealed container.

Observe following precautions during brake bleeding procedure.

DO NOT allow master cylinder to run out of fluid when bleeding brakes. Check fluid level frequently and add fluid as necessary.
DO NOT pump brake pedal during bleeding procedure unless directed to do so.
Bleed only one brake system component at a time. Use a bleed hose on each wheel cylinder and caliper bleed screw.
Be sure to tighten each bleed screw when bleeding is complete.
If master cylinder has been overhauled or a new cylinder is to be installed, bench bleed master cylinder before installation.

NOTE: Under most circumstances, only base brake system needs to be bled. Concerning the ABS portion of brake system, if air is suspect in ABS portion of system, particularly the Hydraulic Control Unit (HCU), system must be bled using ABS BLEEDING procedure. See ABS BLEEDING .