Work Procedure

Vehicle specification needs to be written with CONSULT because it is not written after replacing the power steering control module. For details the operation. Refer to "CONSULT Operation Manual".

1. WRITING VEHICLE SPECIFICATION 

   With CONSULT Perform writing vehicle specification to power steering control module according to "Replace ECU" in CONSULT Operation Manual.

   >>

   GO TO 2.

2. PERFORM NECESSARY WORK 

   With CONSULT

   1. Perform configuration. Work Procedure .
   2. Perform adjustment of steering angle sensor neutral position. Work Procedure .
   3. Perform steering torque calibration. Work procedure .
   4. Perform rack reset. Work Procedure .
   5. Perform self-diagnosis for "EPS/DIRECT ADAPTIVE STEERING 3".
   6. Erase the memory of self-diagnosis results.

   >>

   WORK END