Additional Service When Replacing TCM: Description

When replacing the TCM, perform the following work. For work procedure. Refer to Work Procedure .

TCM PROGRAMMING

Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with CONSULT.
CAUTION: When replacing TCM, save TCM data on CONSULT before removing TCM.

CALIBRATION OF G SENSOR

TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the replacement of TCM.

CAUTION: When replacing TCM and transaxle assembly simultaneously, replace transaxle assembly first and then replace TCM.