Work Procedure

SAVING TCM DATA (VEHICLE SPECIFICATIONS)
NOTE: Save necessary data stored in TCM in CONSULT according to the following instructions:

With CONSULT
1. Turn ignition switch OFF.
2. Turn ignition switch ON.
3. Select "Re/programming, Configuration".
4. Select "TRANSMISSION".
  NOTE: If "TRANSMISSION" is not displayed and TCM data cannot be saved on CONSULT, GO TO 3.
5. Select "Programming".
6. Save TCM data on CONSULT according to the CONSULT display.
GO TO 2.
REPLACE TCM
1. Turn ignition switch OFF and wait for 10 seconds.
2. Replace TCM. Refer to Removal and Installation .
GO TO 3.
WRITE TCM DATA (VEHICLE SPECIFICATIONS)
NOTE: Write data saved in CONSULT into a new TCM according to the following instructions:

With CONSULT
1. Select "Programming".
2. Perform programming according to the CONSULT display.
GO TO 4.
LOAD CALIBRATION DATA
1. Turn ignition switch OFF and wait for 10 seconds or more.
2. Shift the selector lever to the "P" position.
3. Turn ignition switch ON.
4. Check that "P" is displayed on shift position indicator on combination meter.
  NOTE: Displayed approximately 4 - 5 seconds after the selector lever is moved to the "P" position.
Does the shift position indicator display "P"?

YES

GO TO 5.

NO

GO TO 7.
STORE CALIBRATION DATA
1. Turn ignition switch OFF and wait for 5 seconds.
2. Turn ignition switch ON.
Does the shift position indicator display "P" at the same time when turning ON the ignition switch?

YES

GO TO 6.

NO

Check harness between battery and TCM harness connector terminal. Refer to Diagnosis Procedure .
CALIBRATE G SENSOR
Refer to Description .

WORK END
DETECT MALFUNCTIONING ITEM
Check the following items:
- Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
- Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals
Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace the malfunctioning parts.