Removal And Installation: Notes

WARNING: This page is about a different car, the 2017 Nissan Versa Note. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Position the vehicle on a flat and solid surface.
Place chocks at front and back of rear wheels.
Attach proper slingers and bolts described in PARTS CATALOG if engine is not already equipped.

CAUTION:

Always be careful to work safely.
Do not start working until exhaust system and coolant are cool enough.
If items or work required are not covered by the engine article, refer to the applicable service information.
Always use the support point specified for lifting.
Use either 2-pole lift type or separate type lift. If board-on type must be used, support the rear axle jacking point with a transmission jack or similar tool before starting work, in preparation for the backward shift of center of gravity.
For supporting points for lifting and jacking point at rear axle, refer to 2-POLE LIFT .

NOTE:

When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
Remove the engine and the transaxle assembly from the vehicle downward. Separate the engine and the transaxle.