AV Communication Line Check (Between Display Control Unit and AV Switch)

1. Turn ignition switch OFF.
2. Disconnect display control unit connector and AV switch connector.
3. Check continuity between display control unit and AV switch.
   TERMINALS CONTINUITY REFERENCE
   
   

   Terminals				Continuity
   Display control unit (+)		AV switch (-)
   Connector	Terminal (Wire color)	Connector	Terminal (Wire color)
   M95	28 (V)	M98	6(V)	Yes
   	30 (LG)		8(LG)

4. Check continuity between display control unit and ground.

Fig 1: Checking Continuity Between Display Control Unit & Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

1. OK: GO TO 2.
2. NG: Repair harness or connector.

1. Connect display control unit connector and AV switch connector.
2. Turn ignition switch ON.
3. Check signal between display control unit harness connector M95 terminal 28 (L) and 30 (LG) with CONSULT-II or oscilloscope.
   1. 28 (L), 30 (LG) - Ground:  Refer to "TERMINALS AND REFERENCE VALUE FOR DISPLAY CONTROL UNIT  ".
   Fig 2: Checking Signal Between Display Control Unit Harness Connector Terminal With CONSULT-II Or Oscilloscope

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

1. OK: Replace AV switch. Refer to REMOVAL AND INSTALLATION FOR AV SWITCH .
2. NG: Replace display control unit. Refer to REMOVAL AND INSTALLATION OF NAVI CONTROL UNIT  .