LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1192 (2004.5 - Brake System - Sedan) >> Rear Disc Brake >> Pad Replacement >> Installation

Pad Replacement: Installation

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply brake grease to the back of pad and both sides of shim, and install inner shim and inner shim cover to inner pad, and outer shim and outer shim cover to pad.
  2. Apply disc brake grease to the pad contact surface on the pad retainer, and install pad retainers and pads to torque member.
  3. Install cylinder body to torque member.
    CAUTION: When replacing pads with new ones, press in the piston until pads can be installed. In this case, carefully monitor the brake fluid level in the reservoir tank because brake fluid will return to reservoir tank of master cylinder.
  4. Insert lower sliding pin bolt to tighten to the specified torque. Refer to "COMPONENT  ".
  5. Check brake for drag.
  6. Install tire.
scientia non olet · About LEMON Manuals