LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2004 >> Lancer Evolution >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Overhaul - Evolution >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> Q << Snap Ring Installation

>> Q << Snap Ring Installation

  1. Install the thickest snap ring that can be fitted in the groove of output shaft.
  2. Make sure that the taper roller bearing end play meets the standard value.
    1. Standard value: 0-0.09 mm (0-0.0035 inch) 
    Fig 1: Installing Snap Ring
    G00977760Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals