61 31 008 Removing and installing (replacing) steering column switch cluster

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Shift wheels into straight-ahead position and do not alter this position during the repair work.
Do not under any circumstances turn the steering column switch cluster when the steering wheel

Preliminary work needed:

Remove SPORTS STEERING WHEEL/STEERING WHEEL
Remove the TOP SECTION OF STEERING COLUMN CASING
Remove STEERING COLUMN SHROUD LOWER SECTION

Removal:

Unscrew the screws (1).

Remove steering column switch cluster (2) in arrow direction.

Fig 1: Removing Steering Column Switch Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (1) on steering column switch cluster (2).

Fig 2: Disconnecting Connector On Steering Column Switch Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect connector (1) to steering column switch cluster (2).

Fig 3: Connecting Connector On Steering Column Switch Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check neutral position of coil spring on steering column switch cluster.
Neutral position is correct only when the green or yellow mark (1) is clearly visible!

Fig 4: Locating Yellow Mark Area

Courtesy of BMW OF NORTH AMERICA, INC.

Install steering column switch cluster in arrow direction.

Retain steering column switch cluster pressed firmly against the steering column.

Tighten screws (1 to 4) in the order displayed.

Tightening torque 61 31 3AZ .

Fig 5: Tightening Steering Column Switch Cluster Screws

Courtesy of BMW OF NORTH AMERICA, INC.