LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2012 >> Cooper Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Steering Column) >> Removal & Installation >> Steering Column >> Installation

Steering Column: Installation

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, 2001 BMW X5, and 2000 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Ensure installation of screw (1), spacer tube (2), guide bush (3) and shim (4). See Figure .
  2. Install bracket (1), spacer (2), bolt (3), plastic guide (inner surfaces lightly greased) (4) and washer (5). Replace self-locking nut (6). See Figure . Tighten nut to specification. See TORQUE SPECIFICATIONS  .
  3. Fit spacer tube. Tighten new shear off screws until screw heads shears off. See Figure .
  4. Ensure clamping screw is located in retaining groove of steering spindle. See Figure . Replace self-locking nut and tighten to specification. See TORQUE SPECIFICATIONS  .
  5. When installing collar, check position of collar (1) with regard to snap ring (2). See Figure .
  6. After installation, carry out steering angle offset for Dynamic Stability Control (DSC). See BMW Diagnosis Program.
  7. Check for freedom of movement over entire adjustment range of steering column to adjoining components and wires.
  8. Carry out mechanical (lock cylinder, steering lock, interlock) and electrical (ignition, radio etc.) function checks.
scientia non olet · About LEMON Manuals