LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2003 >> CLK55 >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Entertainment/Navigation, Lighting, Windows -- 203 Chassis) >> Basic Knowledge >> Wiper start suppression function - GF82.30-P-3008PP

Wiper start suppression function - GF82.30-P-3008PP

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

MODELS 203.0 /2 /7 up to 23.4.04 

Safety shutoff of windshield wiper system (WSA) 

The following safety precautions have been taken in order to minimize the risk of injuries:

  1. If the engine hood is opened at a speed of less than 5 km/h, wiper function is immediately aborted. The wipers can operate again only after the engine hood has been closed.
  2. If the engine hood is opened at a speed of 8 km/h, the wiper function is shut off only after the vehicle speed has dropped below 5 km/h. The wiper can only start again when the engine hood is closed again and/or the speed of 8 km/h is exceeded.
  3. When a front door is opened and the wipers are not in the end position when c. 15R is switched on, wiper startup is suppressed. The position of the combination switch (S4) is of no relevance in this connection.
  4. The intermittent wipe function is suppressed at a vehicle speed of less than 5 km/h if one of the front doors is opened.

For safety shutoff, the left front door contact switch (S17/3), the right front door contact switch (S17/4) and the ATA hood switch (S62) are read by the rear SAM control unit with fuse and relay module (N10/2) and relayed over the control area network bus class B (interior) (CAN-B) to the front SAM control unit with fuse and relay module (N10/1).

The speed signal is transmitted via the CAN-B from the instrument cluster (A1) to the front SAM control unit with fuse and relay module (N10/1).

  Combination switch, location/task/design/ function   GF82.30-P-2100PP 
  Wiper motor, location/task/design/function   GF82.30-P-4104PP 
  Front SAM control unit with fuse and relay module location/task/design   GF54.21-P-4108PP
  Rear SAM control unit with fuse and relay module, location / task / design / function   GF54.21-P-4115PP