Windshield washer, function - GF82.35-P-3002PP

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

MODELS 203.0 /2 /7 up to 23.4.04

Function prerequisites:

Circuit 15R ON

Operating procedure

The combination switch (S4), which is read in by the EIS control unit (N73) up to 30.6.03 or the steering column module (N80) as of 1.7.03 is pushed beyond the detent point,
the signal is sent on the class B Controller Area Network bus (interior) (CAN-B),
the front SAM control unit with fuse and relay module (N10/1) receives this message,
the front SAM control unit with fuse and relay module (N10/1) actuates the wiper motor (M6/1) and the windshield washer fluid pump (M5/1).
The windshield washer fluid pump (M5/1) is actuated for as long as the combination switch (S4) is pressed.
When the combination switch (S4) is released the wiper motor (M6/1) shut-off delay feature is actuated.
The number of cycles that are then performed depends on the combination switch (S4) actuation time:
If the actuation time was less than 1 second, one additional wiping cycle is performed.
If the actuation time was longer,
three subsequent wiping cycles are performed. This also applies if the combination switch (S4) was pressed again during the subsequent wiping operation and the overall actuation time is therefore more than 1 second.

If a new request is received after completion of these three subsequent wiping cycles, three additional wiping cycles are performed.
After completion of the subsequent wiping operation, the wiper motor (M6/1) is stopped.

The wiper motor is actuated (M6/1) at stage 1 when the windshield is washed. The motor is only actuated at stage 2 if the wipers have been set to stage 2 and the windshield is washed at the same time.

Windshield washer fluid pump (M5/1) actuation

The windshield washer fluid pump (M5/1) is actuated directly by the front SAM control unit with fuse and relay module (N10/1).

The motor of the windshield washer fluid pump (M5/1) is switched to ground via an electronic switch (transistor) by the front SAM control unit with fuse and relay module (N10/1) when washing.

In the event of overload, the front SAM control unit with fuse and relay module (N10/1) shuts the windshield washer fluid pump (M5/1) off.

Slowing down wiper motor, function		GF82.30-P-4007PP
Anti-block device for wiper motor, function		GF82.30-P-4008PP
Combination switch, location/task/design/ function		GF82.30-P-2100PP
Wiper motor, location/task/design/function		GF82.30-P-4104PP
Windshield washer fluid pump location/task		GF82.35-P-4108PP
Upper control panel control unit, location/task/ design/function		GF54.21-P-4105PP
Electronic ignition switch control unit, location/ task/design/function		GF80.57-P-4102PP
Steering column module location/task	In vehicles as of 1.7.02	GF54.21-P-4125Q
Front SAM control unit with fuse and relay module location/task/design		GF54.21-P-4108PP