Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PID [FUEL_PRES]. (Refer to PID/DATA MONITOR INSPECTION .) .) (Refer to PID/DATA MONITOR TABLE [PCM(VIN Y)] .) .)
- Compare the voltage and fuel pressure indications for the PID [FUEL_PRES] with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)
VOLTAGE SPECIFICATION - STANDARD
| FUEL_PRES | Remarks | |
|---|---|---|
| V | MPa {kgf/cm2 , psi} | |
| Approx. 0.83-0.9 | 2.75-3.25 {28.1-33.1, 399-471} | Idle (after warm up) |