Keyless Receiver Inspection: Notes

Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Wind blocker (See WIND BLOCKER REMOVAL/INSTALLATION .)
2. Seat (LH) (See SEAT REMOVAL/INSTALLATION .)
3. Scuff plate (LH) (See SCUFF PLATE REMOVAL/INSTALLATION .)
4. Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
5. Side shelf (LH) (See SIDE SHELF REMOVAL/INSTALLATION .)
Disconnect the connector from the keyless receiver.
Remove the keyless receiver. (See KEYLESS RECEIVER REMOVAL/INSTALLATION .)
Reconnect the connector.
Connect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
  - If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver. (See KEYLESS RECEIVER REMOVAL/INSTALLATION .)