LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Interior Trim) >> Upper Panel Removal/Installation

Upper Panel Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    2. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
    3. Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [C66M-R] .)
    4. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    5. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
    6. Rear console component (See REAR CONSOLE REMOVAL/INSTALLATION .)
    7. Console side panel No. 1 (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
  3. Remove the screws.
    Fig 1: Upper Panel Component And Screws
    G12236531Courtesy of MAZDA MOTORS CORP.
  4. Remove the upper panel component in the direction of the arrows shown in the figure below.
    Fig 2: Upper Panel Component
    G12236532Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals