LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2019 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Interior Trim) >> Trunk End Trim Removal/Installation

Trunk End Trim Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    2. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    3. Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION .)
  2. Partially peel back the seaming welt.
  3. Remove the fasteners.
    Fig 1: Trunk End Trim And Fasteners
    G12236524Courtesy of MAZDA MOTORS CORP.
  4. Pull the trunk end trim in the direction of the arrow in the order of (1), (2) shown in the figure below while detaching clips, pins, and guides.
    Fig 2: Pulling Trunk End Trim
    G12236525Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals