Selection Of Procedure For 360° View Monitor System Aiming
WARNING: This page is about a different car, the 2018 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- For the front camera aiming, side camera aiming, and rear mount camera aiming, 1 set (1 set/2 targets) of the SST (49 JP04 001) are required.
- For the 360° view monitor system aiming (batch aiming), 4 sets (1 set/2 targets) of the SST (49 JP04 001) are required. If 4 sets of the SST (49 JP04 001) is unavailable, perform the aiming for the 4 cameras individually.
- When any of the following operations is performed, it is necessary to verify if the front camera aiming, side camera aiming, and rear mount camera aiming needs to be performed.
- Servicing requiring verification of necessity to perform front camera aiming
- Front camera removal/installation
- Front bumper removal/installation
- Servicing requiring verification of necessity to perform side camera aiming
- Side camera removal/installation
- Power outer mirror removal/installation
- Lower outer mirror garnish removal/installation
- Side turn light removal/installation
- Front door removal/installation or adjustment
- Servicing requiring verification of necessity to perform rear mount camera aiming
- Rear mount camera removal/installation
- Liftgate removal/installation or adjustment
- Rear finisher removal/installation
Step Procedure Action After Procedure 1 Was the 360° view monitor control module replaced? Yes Go to step 4. No Go to the next step. 2 To determine if aiming is necessary or not, perform the 360° view monitor system screen display verification procedure.
(See 360° VIEW MONITOR SYSTEM SCREEN DISPLAY VERIFICATION PROCEDURE )
Is it necessary to perform aiming?Yes Go to the next step. No Procedure is completed. 3 Which of the cameras requires aiming? Front camera Perform the front camera aiming and go to step 5.
(See FRONT CAMERA AIMING PROCEDURE )Side camera Perform the side camera aiming and go to step 5.
(See SIDE CAMERA AIMING PROCEDURE )Rear mount camera Perform the rear mount camera aiming and go to step 5.
(See REAR MOUNT CAMERA AIMING PROCEDURE )4 For the 360° view monitor system aiming (batch aiming), 4 sets of the SST (49 JP04 001) are required.
Are 4 sets of the SST (49 JP04 001) available?Yes Perform the 360° view monitor system aiming (batch aiming) procedure and go to step 5.
(See 360° VIEW MONITOR SYSTEM AIMING (BATCH AIMING) PROCEDURENo Individually perform aiming for the camera requiring aiming, then go to Step 5.
(See FRONT CAMERA AIMING PROCEDURE )
(See SIDE CAMERA AIMING PROCEDURE )
(See REAR MOUNT CAMERA AIMING PROCEDURE )5 Perform the 360° view monitor system screen display verification procedure. (See 360° VIEW MONITOR SYSTEM SCREEN DISPLAY VERIFICATION PROCEDURE )
Is 360° view monitor system aiming procedure needed?Yes Repeat Step 4. No Procedure is completed.