LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> CX-5 Touring, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Lower Panel Removal/Installation >> Driver-side

Lower Panel Removal/Installation: Driver-side

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
  2. Remove the following parts:
    1. Driver-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION ).
    4. Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION ).
    5. Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [C66M-R] ).
    6. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION ).
    7. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION ).
    8. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION ).
    9. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION ).
    10. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
    11. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION ).
    12. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
  3. Remove the screw A.
    Fig 1: Removing Lower Panel (Driver-Side)
    G09077221
  4. Take the shaded area shown in the figure, and pull the driver-side lower panel in the direction of the arrow in the order of (1), (2), (3),(4) and remove it while detaching clips B, hooks C and pins D.
  5. Disconnect the car-navigation unit connector, (with car-navigation system)
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals