Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM PCM DTC INSPECTION Perform the PCM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [L5] .) (See ON-BOARD DIAGNOSTIC TEST [MZI-3.7] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [L5] .) (See DTC TABLE [MZI-3.7] .)
1		No	Go to the next step
2	INSPECT FUSE Switch the ignition to off. Disconnect the negative battery cable. Remove the ENG+B 10 A fuse. Inspect the ENG+B 10 A fuse. Is there any malfunction?	Yes	Replace the ENG+B 10 A fuse, then go to Step 7.
2		No	Go to the next step.
3	INSPECT BATTERY Inspect the battery. (See BATTERY INSPECTION [L5] .) (See BATTERY INSPECTION [MZI-3.7] .) Is there any malfunction?	Yes	Recharge or replace the battery, then go to Step 7. (See BATTERY RECHARGING [L5] .) (See BATTERY RECHARGING [MZI-3.7] .) (See BATTERY REMOVAL/INSTALLATION [L5] .) (See BATTERY REMOVAL/INSTALLATION [MZI-3.7] .)
3		No	Go to the next step.
4	INSPECT GENERATOR Inspect the generator. (See GENERATOR INSPECTION [L5] .) (See GENERATOR INSPECTION [MZI-3.7] .) Is there any malfunction?	Yes	Replace the generator, then go to Step 7 (See GENERATOR REMOVAL/INSTALLATION [L5] .) (See GENERATOR REMOVAL/INSTALLATION [MZI-3.7] .)
4		No	Go to the next step
5	INSPECT KEYLESS CONTROL MODULE CONNECTOR CONDITION Disconnect the keyless control module connector Inspect the connector and terminals (corrosion, damage, pin disconnection) Is there any malfunction?	Yes	Repair or replace the connector or terminals, then go to Step 7
5		No	Go to the next step
6	INSPECT BATTERY POWER SUPPLY CIRCUIT (+B2) FOR SHORT TO GROUND OR OPEN CIRCUIT Install the ENG+B 10 A fuse. Reconnect the negative battery cable Measure the voltage between keyless control module terminal 1E (wiring harness-side) and body ground Is there any voltage?	Yes	Go to the next step.
6		No	Repair or replace the wiring harness for a possible short to ground or open circuit, then go to the next step.
7	VERIFY TROUBLESHOOTING COMPLETED Make sure to reconnect the disconnected connectors Reconnect the negative battery cable. Clear the DTC from keyless control module memory using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Is the same DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the keyless control module, then go to the next step. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
7		No	Go to the next step
8	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
8		No	DTC troubleshooting completed.