No.3 Additional Key Programming Procedure Changing: Procedure

WARNING: This page is about a different car, the 2013 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Step	Procedure	Action after procedure
1	CHANGE CUSTOMER SPARE KEY PROGRAMMING PROCEDURE Connect the M-MDS (IDS) to the DLC-2. (See M-MDS CONNECTING PROCEDURE .) Switch the ignition ON using a key (the key can be either the valid key or an unprogrammed key). NOTE: If an unprogrammed key is used, the security light starts flashing and DTC 15 is displayed after approx. 1 min. However, this does not indicate an improper procedure. Continue to perform the procedure as indicated. After the vehicle is identified, select the following items from the initialization screen of the IDS. Select "Body". Select "Security". Select "PATS Functions". Select either of the following from the M-MDS (IDS) menu to change the additional key programming procedure. When "Customer Spare Key Programming Enable" is selected: The additional key programming procedure using valid keys is enabled. When "Customer Spare Key Programming Disable" is selected: The additional key programming procedure using valid keys is disabled. Perform the security access according to the directions on the M-MDS (IDS) screen. After verifying that the PATS function menu is displayed again on the M-MDS (IDS) screen, select "Finish (this menu)". Switch the ignition to off.	Procedure is completed