LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transaxle [Shift Mechanism]) >> Key Interlock System Inspection >> NOT P Position Switch Inspection

NOT P Position Switch Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Perform the following procedures.
    1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
    2. Disconnect the negative battery cable.
    3. Remove the console. (See CONSOLE REMOVAL/INSTALLATION .)
    4. Disconnect the selector lever component connector.
      Fig 1: Identifying Selector Lever Component Connector
      G06732789Courtesy of MAZDA MOTORS CORP.
  2. Inspect the continuity between the selector lever component terminals G and K.
    • If there is any malfunction, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)

      NOT P position switch specification 

      CONTINUITY CHART

      Test condition Continuity
      P position No continuity
      Except P position Continuity
      Fig 2: Identifying Selector Lever Component Terminals
      G06732790Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals