Advanced Key Does Not Operate (09-013/09)

WARNING: This page is about the 6 i Grand Touring, 2.5 A, Automatic, which is a different variant/trim than selected.

Publication date: 2009-03-18
Reference number: 09-013/09

ADVANCED KEY DOES NOT OPERATE

TECHNICAL SERVICE BULLETIN

Reference Number(s): 09-013/09, Date of Issue: 03/18/2009

MAZDA:

2009 MAZDA6

APPLICABLE MODEL(S) / VINS

2009 MAZDA6

DESCRIPTION

Some customers may complain that the advanced key does not work at all. This may be due to poor contact caused by an oxidation between the battery and the transmitter terminals.

The coating procedure for the terminals inside the transmitter has been changed during mass-production to eliminate this concern.

Customer's having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

Verify concern.
Remove auxiliary key from back of transmitter body.
Verify transmitter build date code at bottom right corner of transmitter body.
- If transmitter date code is BEFORE 11/28/08, proceed to Step 4.
- If transmitter date code is AFTER 11/28/08, refer to Workshop Manual diagnostics.
Replace advanced key transmitter.
Perform transmitter programming using Mazda Modular Diagnostic System (M-MDS) to allow security access to smart keyless entry system.
Confirm doors can be locked / unlocked and engine can be started with new transmitter.
Destroy old transmitter.

PART(S) INFORMATION

PART INFORMATION

Part Number	Description	Qty.
GSYL-67-5RY	Transmitter	1

WARRANTY INFORMATION

NOTE:

This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
This repair will be covered under Mazda's New Vehicle Limited Warranty term.
Additional diagnostic time cannot be claimed for this repair.

WARRANTY INFORMATION

Warranty Type	A
Symptom Code	61
Damage Code	9R
Part Number Main Cause	GSYL-67-5RY
Quantity	1
Operation Number / Labor Hours:	XXE05XRX / 0.3 Hrs.