LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> CX-7 Sport, FWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Rear Power Window Regulator Removal/Installation

Rear Power Window Regulator Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the sail garnish. (See SAIL GARNISH REMOVAL/INSTALLATION ).
  3. Remove the rear door garnish. (See REAR DOOR GARNISH REMOVAL/INSTALLATION ).
  4. Remove the rear door trim. (See REAR DOOR TRIM REMOVAL/INSTALLATION ).
  5. Remove the rear door speaker. (See REAR DOOR SPEAKER REMOVAL/INSTALLATION ).
  6. Remove the rear door glass. (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
  7. Remove the power window motor. (See POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
  8. Remove the nuts.
    Fig 1: Rear Power Window Regulator Fasteners With Torque Specifications
    G04861005Courtesy of MAZDA MOTORS CORP.
  9. Insert a hand through the speaker installation hole, rotate the drum housing in the direction shown in the figure to detach the tabs from the rear door unit.
    Fig 2: Identifying Drum Housing
    G04861006Courtesy of MAZDA MOTORS CORP.
  10. Remove the rear power window regulator through the speaker installation hole.
  11. Install in the reverse order of removal.
    CAUTION:
    • Make sure the cable does not unspool from the drum housing when installing.
      Fig 3: Identifying Rear Power Window Regulator
      G04861007Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals