Power Window Motor Removal/Installation

Fully lower the rear door glass.
Disconnect the negative battery cable.
Remove the following parts:
Front door
- Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION )
- Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION )
Rear door
- Sail garnish (See SAIL GARNISH REMOVAL/INSTALLATION )
- Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION )
Remove the bolts.
Remove the power window motor from the power window regulator.
Disconnect the power window motor connector.
Install in the reverse order of removal.
NOTE:
- When installing the power window motor to the power window regulator drum, the drum housing tabs may detach from the door module. If this happens, insert a hand through the speaker installation hole to engage the drum housing tabs, and install the power window motor to the drum while supporting the drum housing.
  
  Fig 1: Power Window Motor Fasteners With Torque Specifications
  Courtesy of MAZDA MOTORS CORP.