HEIGHT CONTROL VALVE (for Front Side): Installation

INSTALL NO. 1 HEIGHT CONTROL VALVE SUB-ASSEMBLY
1. Install the height control valve with the 2 nuts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 1: Locating Height Control Valve And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 3 side air tubes (see SUSPENSION CONTROL SYSTEM ).
  
  Fig 2: Connecting Side Air Tubes
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the underside air tube (see SUSPENSION CONTROL SYSTEM ).
  
  Fig 3: Connecting Underside Air Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL COWL TOP VENTILATOR LOUVER RH (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
INSPECT FOR AIR LEAK
1. Inspect for air leak (see OPERATION CHECK ).
INSTALL FRONT BUMPER COVER (See INSTALLATION )
INSTALL FRONT FENDER LINER LH (See INSTALLATION )
INSTALL FRONT FENDER LINER RH (See INSTALLATION )
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (See INSTALLATION )
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (See INSTALLATION )
INSTALL FRONT FENDER WHEEL OPENING MOULDING LH (See INSTALLATION )
INSTALL FRONT FENDER WHEEL OPENING MOULDING RH (See INSTALLATION )
INSTALL RADIATOR GRILLE ASSEMBLY (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )