Front Airbag Sensor: Installation

INSTALL FRONT AIRBAG SENSOR LH
1. Check that the engine switch is off.
2. Check that the cable is disconnected from the battery negative (-) terminal.
  CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
3. Connect the connector.
4. Install the front airbag sensor with the 2 bolts.
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
  
  Fig 1: Locating Bolts And Front Airbag Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
5. Check that there is no looseness in the installation parts of the front airbag sensor.
INSTALL HEADLIGHT ASSEMBLY LH
1. Install the headlight assembly LH (see INSTALLATION ).
INSTALL FRONT BUMPER COVER
1. Install the front bumper cover (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT (See DISPOSAL )
ADJUST HEADLIGHT ASSEMBLY LH
1. Adjust the headlight assembly LH (see ADJUSTMENT )