LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Transfer Case) >> Transfer Valve Body Assembly >> Removal

Transfer Valve Body Assembly: Removal

WARNING: This page is about a different car, the 2007 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN AUTOMATIC TRANSMISSION FLUID (See  REMOVAL  ) 
  2. REMOVE REAR NO. 1 FLOOR PANEL BRACE (See  REMOVAL For (2GR-FSE) REMOVAL For (4GR-FSE)  ) 
  3. REMOVE FRONT CENTER FLOOR BRACE (See  REMOVAL For (2GR-FSE) REMOVAL For (4GR-FSE)  ) 
  4. DISCONNECT HEATED OXYGEN SENSOR (See  REMOVAL For (2GR-FSE) REMOVAL For (4GR-FSE)  ) 
  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (See  REMOVAL For (2GR-FSE) REMOVAL For (4GR-FSE)  ) 
  6. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR (See  REMOVAL  ) 
  7. SUPPORT AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (See  REMOVAL  ) 
  8. REMOVE ENGINE REAR MOUNTING MEMBER (See  REMOVAL   ) 
  9. REMOVE TRANSFER DYNAMIC DAMPER (See  REMOVAL   ) 
  10. REMOVE TRANSFER OIL PAN (See  REMOVAL   ) 
  11. REMOVE TRANSFER VALVE BODY ASSEMBLY 
    1. Remove the 4 bolts and the transfer upper valve body.
    2. Disconnect the transfer wire connector from the transfer control solenoid.
  12. REMOVE TRANSFER CONTROL SOLENOID (See  DISASSEMBLY   ) 
    Fig 1: Identifying Transfer Wire Connector With Bolts
    G05295959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals