How To Proceed With Troubleshooting
The hand-held tester can be used at step 3 4 6 9.
HINT:
The ECM of this system is connected to the multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the multiplex communication system.
- Vehicle Brought to Workshop
- Go to next step.
- (See CUSTOMER PROBLEM ANALYSIS CHECK
)
- Go to next step.
- Connect the OBD II scan tool or hand-held tester to DLC3
- Go to next step.
- Check and Clear DTC and Freeze Frame Data (See PRE-CHECK
)
- Go to next step.
- Visual Inspection
- Go to next step.
- Setting the Check Mode Diagnosis (See PRE-CHECK
)
- Go to next step.
- Problem Symptom Confirmation
- Symptom does not occur: Go to step 8
- Symptom occur: Go to step 9
- Symptom Simulation (See HOW TO PROCEED WITH TROUBLESHOOTING
)
- Go to next step.
- DTC Check (See PRE-CHECK
)
- DTC is not output: Go to step 10
- DTC is output: Go to step 17
- Basic Inspection (See
AUTOMATIC TRANSAXLE FLUID (ATM)
,
PARK/NEUTRAL POSITION SWITCH ASSY (ATM)
and
SHIFT LEVER ASSY (ATM)
)
- NG: Go to step 19
- OK: Go to next step.
- Mechanical System Test (See 12
)
- NG: Go to step 16
- OK: Go to next step.
- Manual Shifting Test (See 14
)
- NG: Go to step 14
- OK: Go to next step.
- Problem Symptoms Table Chapter 1 (See PROBLEM SYMPTOMS TABLE
)
- NG: Go to step 18
- OK: Go to next step.
- Problem Symptoms Table Chapter 2 (See PROBLEM SYMPTOMS TABLE
)
- NG: Go to step 16
- OK: Go to next step.
- Problem Symptoms Table Chapter 3 (See PROBLEM SYMPTOMS TABLE
)
- NG: Go to next step.
- Part Inspection
- Go to step 19
- (See DIAGNOSTIC TROUBLE CODE CHART
)
- Go to next step.
- Circuit Inspection (See DTC P0705 TRANSMISSION RANGE SENSOR CIRCUIT MALFUNCTION (PRNDL INPUT)
)
- Go to next step.
- Identification of Problem
- Go to next step.
- Repair
- Go to next step.
- Confirmation Test
- End