LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> RX 330 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Starting) >> Starter >> Installation

Section 571 (Starting): Starter: Installation

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (380 kgf*cm, 28 ft.*lbf) 

      Fig 1: Identifying Starter Assembly Bolts
      G04975667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the wire harness to terminal 30 and install the nut, and then attach the terminal cap.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Connect the terminal 50 connector to the starter assembly.
  2. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  6. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  9. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).

      HINT:

      Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.

scientia non olet · About LEMON Manuals