Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Electrical cause
- Yes
- Mechanical cause
- Yes
- Control module cavity
- Circuit reference G_G_CR S
- Circuit reference O_V_5VCRS
- Circuit reference I_F_CRS
- The powertrain control module detected the low pulse is too narrow with respect to time
- Crankshaft position sensor incorrectly installed
- Crankshaft position sensor air gap to target rotor excessive, debris on sensor face, damaged teeth on rotor
- Crankshaft position sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Crankshaft position sensor failure