DTC P016D-26 Excessive Time To Enter Closed Loop Fuel Pressure Control - Signal rate of change below threshold: Action
WARNING: This page is about a different variant/trim than selected.
- Check powertrain control module for fuel related Diagnostic Trouble Code(s) and refer to relevant Diagnostic Trouble Code(s) index
- Refer to the appropriate system wiring diagrams and check connections are secure and wiring integrity
- Check crankshaft position sensor for correct installation
- Check crankshaft position sensor air gap to target rotor is correct, remove any debris from sensor face, check for damaged teeth on rotor
- Refer to the appropriate system wiring diagrams and check the crankshaft position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress and pins for damage and/or corrosion
- Check fuel rail system for mechanical integrity
- Check powertrain control module for mechanical integrity
- Check and install a new crankshaft position sensor as required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest