DTC P0710-64: Transmission Fluid Temperature Sensor "A" Circuit - Signal plausibility failure: Action

NOTE:

Automatic transmission fluid temperature sensor resistance specification is 1 kΩ at 25°C.
After installing a new transmission control module, perform routines - Configure New Module (Without Transmission Replacement), Transmission Control Module Adaption.

Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signal - Transmission Oil Temperature (0x1E69). Refer to the appropriate system wiring diagram and check the automatic transmission fluid temperature sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness or install a new sensor unit as necessary
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new transmission control module