DTC P025C-11: Fuel Pump Module "A" Control Circuit Low - Circuit short to ground: Action
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
New components should only be installed when diagnosed as failed
- Vehicle Conditions to enable DTC Logging strategy
- Ignition ON, engine running for 30 seconds
- Prioritized Checks to Perform
- Refer to the appropriate system wiring diagrams and check the output PWM signal from engine control module to fuel pump driver module circuit for short circuit to ground, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new fuel pump driver module, only when diagnosed as failed
- Check and install a new engine control module, only when diagnosed as failed
- Using the manufacturer approved diagnostic system clear all stored DTCs using the Diagnosis Menu tab and retest