Power Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF".
- Refer to "RAIN SENSOR " and disconnect Rain Sensor connector.
- Ignition "ON".
- Measure voltage between Pin No. 1 (Memory Power) terminal of Rain Sensor harness connector and chassis ground.
Specification: Approx. 12V
- Is the measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit between Rain Sensor and Battery and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.