Power Circuit Inspection
WARNING: This page is about a different car, the 2016 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition "OFF"
- Refer to "PAS SENSOR CONNECTOR REMOVAL " and disconnect Front & Rear PAS Sensor connector.
- Ignition "ON"
- Measure voltage between Pin No. 6 (Power) terminal of each Front & Rear PAS sensor harness connector and chassis ground.
Specification: Approx. 12 V
- Is measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit between concerned Front & Rear PAS Sensor and Battery and then go to "Verification Of Vehicle Repair " procedure.