6F24 Transmission Verification Test
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Perform the following after completion of a diagnostic repair:
- Reconnect any disconnected components.
- Connect the scan tool to the Data Link Connector (DLC).
- With the scan tool, erase all Transmission and Engine DTCs.
- If the transmission or valve body has been replaced, a Clear Learned Values procedure must be performed with the scan tool.
- With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
- Check the Transmission fluid level and adjust if necessary. Refer to the service information for the Fluid Fill procedure.
- Road test the vehicle allowing the vehicle to shift through all gears.
- Check for DTCs during and after the road test.
Were there any Diagnostic Trouble Codes (DTCs) set during the road test?
Yes
- Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
No
- Repair is complete.